2. analog
  3. 1235866447

tonearm mass/cartridge mismatch

What would happen if the tonearm mass is too low or too high for a given cartridge? What is a less disastrous mismatch: a heavy tonearm with a light(less than 10 grams) high compliance cartridge or a light tonearm with a heavier and low compliance cartridge? Whould the combination of a heavy tonearm and a light cartridge lead to a lower resonance frequency?

Chris
dazzdax
markpao
520 posts
 
I didn't think any of these combinations mattered as long as the resonant frequency ends up between 8-12 hertz?
syntax's avatar
syntax
2,193 posts
 
I didn't think any of these combinations mattered as long as the resonant frequency ends up between 8-12 hertz?

Well, it is only 1 information. Arm tubes today are made of Ceramic, different Wood, Titanium, Steel, Aluminum, are damped or not, then there are different qualities of bearings and some more...
dazzdax OP
599 posts
 
If I'm using the relatively heavy SME 3012 Series II 12 inch tonearm with the Transfiguration Spirit Mk II cart, could I reduce the tonearm mass a bit by using a light magnesium headshell? Is that recommendable? Thank you.

Chris
More to discover