A decent set of beginner advice to care of vinyl

Platogirl-

For a small investment, as long as you have a home vac, I second the KAB cleaner http://www.kabusa.com/frameset.htm?/. You'll be able to develop much more of a 'routine'-it will still be drudgery, but more of a linear, assembly-line sort of drudge that will definitely speed things up. Plus, you'll have better results-and I'm sure I don't need to tell you that you only want to clean your record collection once.

If you've got the money, the VPI 16.5 is the next step up for speed. Yes, Nitty Gritty has RCMs for less, but the VPI is much easier to use, and worth the extra money. The record rotates on a full-sized turntable, allowing you to apply some pressure to the brush/fluids, and the whole operation faces up at you-there's no need to flip the record in order to vacuum. They're often available used here on Agon.

Lots of good info presented already. If you want cheap but more efficient and effective than hand washing and drying; You can purchase a small shop vac (about 30 dollars) and make a very good wet vac. Just take the crevice tool and cut a 1/4 groove along the round edge of the crevice tool. Glue a felt strip along each side of the groove you just cut and partially tape the end of the crevice tool to get the vacuum pulling thru the velvet strip. Walla, you have a very good vacuum. Second, go buy a junk turntable from a thrift shop (got an old kenwood for 10 dollars) and use that to put the record on to clean. It makes a stable platform that you can spin while scrubbing and vacuuming.
you can make your own cleaning solution or buy a cleaning solution. My cheap homemade version is 1 teaspoon of dawn dishwashing detergent, one quart of distilled water and three ounces of isopropyl alcohol. Now you have enough cleaning solution to last a while. Also, the commercial cleaners are very good especially the enzyme based and pretty cheap in the grand scheme of things. I use both types depending on the record grunge. Finally the brushes, MOFI, LAST, Walker, etc all make very good microfiber brushes that help get the grunge out of the groove. My regime is to spray or apply the cleaner, Let sit for a few min, then scrub with a brush. Then i vacuum up this mixture and apply a rinse with distilled water. Scrub with a clean brush (i use separate brushes for rinsing) then vacuum again.
For real dirty records, i will insert steaming steps as part of the initial scrubbing step and rinse.
It takes about 5 min per record but you do once and its clean. I have made a great collection by buying thrift shops, flea markets,etc and cleaning. When you take that one special album and clean it well and it sounds like one right off the press, it make it all worthwhile. i also tend to clean while i listen to music so its not too bad though cleaning is a chore. I have a collection up to about 1500-2000 with most coming from sources that needed to be cleaned well.

In response to Platogirl - If you want speed, and these are not valuable records - Then don't worry about the labels. Just dump 10 records at a time into the soapy water, let 'em soak a couple of minutes (which will really help ease the removal of dirt), then rinse each under running water while using a Disc Doctor pad. I once bought a huge collection that needed this treatment, and it was very fast. Not many labels are that delicate. Many will show a slight texture after drying out, but no big deal. The worst are labels from the 60's, many will lose a little color, but they won't come off the record or disintegrate. The worst are Blue Telefunken labels which tend to lose almost all their color. Original Mercury Living Presence will "run" a bit, but still retain a dark hue. Londons are similar - will color the water, but once dry will look normal. Once you get into the mid-seventies, most labels were plastic coated and are very stable.

Just one suggestion for the "Dawn" crowd. There are a few products which I use for home brew cleaning that are either safer or better:

1. Seventh Generation "Free and Clear" Dish Liquid - no colors or perfumes added, made from plant derived sources.

2. Enzyme based (as mentioned by oilmanmojo above) - will remove tougher mildew and fungus that Dish Soap does not. Best I have found is called MoldZyme - also a plant based product. Enzyme cleaners have to be applied and left sitting 5 minutes or so for best effect.

3. I do not mix alcohol in routinely - if the above two still result in a noisy lp, I will then apply an alcohol/water mix by itself - followed by a little dish soap to finish off.

4. If the alcohol/water hasn't done it, and all appears hopeless - I try Goo Gone. Yes - it is a powerful solvent, but it has saved many lps from going into the garbage, and I have found no negative effects.