what would work best with a rega planar 2 sitting directly on top of it with the factory feet off, herbie iso-cup with the marble type balls , or stillpoints, or herbies tenderfeet. thanks.
1) The OP is looking for replacement feet, probably for $100 or less. 2) For $1550 you could get a significantly better turntable, as opposed to placing an entry-level turntable on a high-zoot platform.
I do agree with Johnnyb. The CF Cones are about $75.00 for a set of three. Pretty cheap, by comparison to what is out there. The Black Diamond Rega setup at Music Direct costs a lot more than that. If you start going crazy with the platforms, racks, etc., you may be better off with a different table entirely.
Air tubes, sand, gel pads, Vibrapods, cork/rubber blocks ... there are lots of very inexpensive ways to drain the vibration out of a component and isolate it from in-room vibrations as well.
Some simple springs. That is what many platforms use. Get them from Mcmaster Car website. Cost you probably $20. You just need to buy the right amount of springs for the weight of the table. This IME will do better than anything above
You must have a verified phone number and physical address in order to post in the Audiogon Forums. Please return to Audiogon.com and complete this step. If you have any questions please contact Support.