how to remove the platter of Micro Seiki DDX1500

i have a ddx 1000 and an rx1500. in both cases, the platter nests on a conical shaped bearing shaft. the mating parts snug together like morse tapered parts do. i lift the platter with a sharp quick straight up tug and it breaks the mechanical fit between the shaft and the platter. your platter is most likely the same.
don

Thanks for your answer. Do you suggest me give a same tug as you did or warn me not to do it?

Any solution if I would like to oil the bearing or polish the platter?

i found that giving it a firm upward tug was the only way to break that mechanical bond, so go ahead and try. i cleaned the contact surfaces with a soft cloth and left them dry, no oil. the bearings should be oiled as per the mfg.

After the broke up, how did you restore the mechanical bond between the shaft and platter when you want to play record?