2. speakers
  3. 1403935250

REL Magic

I have to report this finding as a breakthrough to a new plateau. For the past four years, I have been running two REL Strata III's, one behind each Maggie 3.6R. RELs have always been known for their hook up at the speaker outputs. By this method of integration, REL boasts that their subs somehow lift the entire system. I have always felt this to be true, especially with one for each amp.
But now, I have just completed DIY signal cables for each sub using the same Neutrik connectors into the subs. I used some 16-gauge OCC copper wire by Furutech in the same terminal scheme as the stock cords. As expected, the bass notes are more extended and better defined, but this phenomenon of improving the whole presentation has also appeared again as even more impressive. Everything across the soundscape is just a bit more sweet and clear. If you have not upgraded your REL signal cables, please do.
128x128jafreeman
nmmusicman
276 posts
 
Kalbi23, to change the mains fuse in the T7, power off the unit and remove the power cord from the IEC inlet. Directly below the IEC inlet is a small rectangular insert that is part of the IEC module. You will then notice a small recess on the top outer edge of the insert. Take a small flat blade screwdriver and with the blade in the recess, gently pry forward. The fuse holder/fuse will pop free and you can then pull the fuse holder/fuse free of the IEC module to change the fuse.

Once you have changed the fuse, insert the fuse holder back in the IEC module ensuring that it is fully seated. Note that it can only be inserted one way so make note of it's direction when removing the holder.
jafreeman's avatar
jafreeman OP
689 posts
 
Sabai, it's nice to hear that you found the same improvements through your REL, and I have Nmmusicman to thank for the fuse idea. I have the SR 20's on order. I have had very good results with Furutech fuses in Maggies.
kalbi23
58 posts
 
Thank you Nmmusicman!
sabai
2,027 posts
 
Jafreeman,

I am an inveterate tweaker and tinkerer and have an open mind to most "fringe" ideas. Thanks for your helpful suggestions.
jafreeman's avatar
jafreeman OP
689 posts
 
I have placed the SR20's into my RELs. They are the same amperage rating as the stock fuses. I am doing some listening comparisons of music well-known to me, and so far, there may be a bit more depth--not sure yet--hard to quantify at this point. I have not changed my sub volumes or crossover points. There may be some burn-in potential--or not--in these rather small fuses. Perhaps it would helo to push the amperage ratings for a larger filament. I have doubled the ratings in my Maggies to 5 amps for tweeter, 10 for midrange and have never had a problem--not worried at all. The SR's certainly do not detract in any way, and it's a fun tweak. My thanks to all.
More to discover