2. analog
  3. 1254864364

Anti skate and tonearm damping query

I have read a number of threads relating to both antiskating and tonearm damping on the JMW 9" Sig.arm and find myself a bit confused.......I have been experimenting a little and have reached the conclusion that I must be deaf. I have not used the additional antiskating system, I have tried twisting and not twisting the leno wire and can hear no difference. If the Leno wire is not twisted therefore no antiskate, will this damage the stylus or the album??
I have also filled the damping well above the taper to the base of the point and still cannot hear 'the music being sucked out' or indeed, an improvement. Do I fill the well up to the point!! and then work backwards. Those that finetune using the damping seem to have some sort of epiphany when the 'sweet' spot is reached.

Can someone please shed light on how I should be going about setting the AS and finetuning the damping on the arm. The table is a scoutmaster with super platter and sds, the cartridge is the dynavector Te Kaitora Rua

Thanks
wes4390
dertonarm
1,042 posts
 
Indeed - God bless america.
Especially so in our troubled times.
Thanks to him, that not all americans always go for the most simple model in everything......
In this sense - good luck to Nsgarch too.
syntax's avatar
syntax
2,193 posts
 
some additional Info:

Antiskating .... The last analog secret
tfkaudio
591 posts
 
Hi Wes,
When I set VTA, i did it by ear only. Didn't even look to see if it was parallel. It's pretty easy to hear when you've got it right. The sound kind of pops into focus. Bass and treble become balanced. Bass is taut, not sloppy. Treble is clean, not strident. When you're off, either bass (too low at the tonearm base) or treble (too high) will dominate and exhibit the sloppy/strident characteristic.
Later on, I saw a post here recommending the 3 x 5 card method (Thanks, Stan). I tried it and found that my arm was exactly parallel to the record surface.
I haven't done it in a while, but I thought that turning the VTA wheel clockwise raises the arm at the pivot point.

Cheers.
wes4390 OP
17 posts
 
Thanks for that Tom............
stanwal's avatar
stanwal
3,147 posts
 
Dertonarm has stated the facts as I have always heard them. If it was that easy to apply the correct force then why, for example. did the Grace 707 bias control give twice the necessary force? It was a well designed arm. I have never heard that a given amount of bias compensation would be correct all across the record, the setting is always a compromise. That said, the compromise I chose is not to use any.
More to discover