Cartridge Question

I am very grateful for all of your advice. As we speak, I am putting a few hours each day on the cartridge to give it time to break in. I am also studying up on how to make the adjustments to VTA, azimuth, etc. I never realized the importance of knowing how to make all of these adjustments myself; especially considering the lack of qualified professionals still practicing this lost art. I am glad that Music Hall took the time to write a detailed owners manual to discuss these issues.

Emorrisiv: Thanks for the heads up on the tools. I sort of got sticker shock after looking at Music Direct's catalog for cartridge set-up tools; which was the main reason I decided to have a my local repair shop do it. Does the size of the scale matter? I have a pretty accurate Pelouze Model SP5 that has a 6 inch wide surface. I believe this is actually a postal scale.

Raul: You mentioned "total capacitance value." If my cartridge specs load capacitance at a range of 150-300 pF, but the receiver specs at 150 pF, would being on the lower end of this scale have any effect? (FYI: The load resistance for both the cartridge and the amps internal phono stage are both spec'd as 47 kOhms). Furthermore, considering the amp only has about 25 hours on it, shouldn't the capacitors have more time on them to break in? (I read some place where a pre-amp needed a cd to be played for about 100 hours to give the capacitors time to break in).

Many thanks for all of your comments!
Scott

Brent it sounds like your scale should be alright. It needs to be accurate to at least two decimal points. Also, you will want to do your scale measurements beside the platter, not on it. Use a deck of cards to make the scale the same height as the platter,then take measurements.I would start on the high side of the recommended tracking force,and go from there.I would also get everything in the "ballpark" and let the cartridge break-in before fine tuning,otherwise you will have a moving target as it settles in.

I believe you can get a "Mint"brand protractor for about $100.00. They are custom made for your specific rig and are one of the best. If nothing else,download a protractor off the web,print it and then glue it to a piece of card stock.These can work just fine.Go slow and be careful.If you get scared, put the stylus guard on.
Pay attention to the VTA specs on your cartridge.The norm is about 20degrees,so there is a little rake to the stylus as it sits in the groove.Also, when you move the VTA the overhang will change,so re-check it.

In the long run you will gain a better understanding of how this stuff works and will also gain a better appreciation and enjoyment from the experience.

have fun,that's why we do this.

e

Dear Scott: Certainly that you today capacitance setting is around the cartridge specs because you have to add to those receiver spec of 150pf the cable capacitance.

In a MM/MI cartridges the capacitance makes a difference especially in the high frequency cartridge response, that's why is so important that the phono stage has capacitance value control/switch.

Regards and enjoy the music,
Raul.