11-29-10: Paperw8
"from where you are getting your data on input capacitance? my whest manual provides no information on input capacitance. an input capacitance of 220pf sounds a bit high even for a moving magnet section."
-----------------
James Henriot.
-----------------
"Speaking of the whest manual, i will point out that there is an error in the chart that shows the latest (post 1 jan 09) load settings. the figure in the manual indicates that DIP switch position 4 selects a 1k ohm resistor, when in reality it is a 1.6k ohm resistor. if you look at the values indicated on the actual circuit board, it too indicates that this switch position is 1.6k ohm - the circuit board is correct and the manual is incorrect."
---------------
Useful info....
Cheers..................M.
"from where you are getting your data on input capacitance? my whest manual provides no information on input capacitance. an input capacitance of 220pf sounds a bit high even for a moving magnet section."
-----------------
James Henriot.
-----------------
"Speaking of the whest manual, i will point out that there is an error in the chart that shows the latest (post 1 jan 09) load settings. the figure in the manual indicates that DIP switch position 4 selects a 1k ohm resistor, when in reality it is a 1.6k ohm resistor. if you look at the values indicated on the actual circuit board, it too indicates that this switch position is 1.6k ohm - the circuit board is correct and the manual is incorrect."
---------------
Useful info....
Cheers..................M.