Benz LP cartridge distortion - any advise?

Woodvale,

I have encountered recently the similar issue - "unpleasant amount distortion and sibilance heard on vocals" -though, in different system (Rega P25 table, RB600 arm, Denon Dl-103 cartridge).

Went down googling last night, and found a discussion of smilar problem with dl-103 on rega.

While I thought my cartridge was aligned perfectly (I am using default Rega protractor), actually it was not, I had to move the cart all the way front on arm and align it there (before its was aliged somewhere in the middle). it worked - sibilance on vocals now seems gone.

the questions is if you hear sibilance on the whole LP? My problem was starting with like second or third track on one side.

So #1 check the cartridge position on the tonearms end. #2 if the problem seen on all tracks, that could be defect of of cartridge (factory re-tip is quite affordable for benz Micro LP, $800 at musical surroundings). #3 might be silly idea, but it could be tabe/arm and cart mismatch (key word hear compliance??)?

Just my two cents...

Hi,
I posted a response at AA. It seems to me that
you have a) an anti-skating problem or b) a needle
going/gone bad. Your symptoms are typical
of a used needle. I have a Benz LP that I retipped
once because it had the same symptoms.
First, you must experiment with anti-skating.
Try it with zero/nothing and move up the dial
to see what happens. If you notice a dramatic
change in sibilance than you have part of the
problem. I say part because if you still have some
sibilance after making drastic adjustments than
perhaps the needle is badly worn. When I
was troubleshooting my Benz LP sibilance issues
I found that the anti-skating worked best at 1
on the SME V anti-skate dial.

The tracking force I settled with is 1.75 as
that seemed to be the clearest sounding
with no sibilance problems. I would experiment
with maximum extremes in either VTF and
antiskate and try to sum the settings. Remember
you are listening to the best settings and not
measuring.

I used 1000ohm when the LP was new and
have tried 47 and 10k ohms. I have settled
with 10k on an aesthetix IO.

If all else fails then I would really be
concerned about the health of the needle.

Good luck
audioquest4life

>>04-07-10: Don_c55
Used cartridges with 100 hrs (????) are usually a rip off<<

Really?

Can you provide any evidence to support this?

Thanks in advance

Audiofeil:

This thread is an example of one!

Why do so many used cartridge ads state "used only 100 Hrs"?

Don C55,

I do not know how many cartridges you have had, but heres how you end up with one having 100 hours. You buy new, and run 40 hours break-in, since all carts sound awfully different, in next 50 hours you realise that it is not your cup of tea (while its obvious form the start that this is not the thing you want, everyone just go through that 40 hours barrier to see how actually cart performs).

Of course that does not mean, that all seller are honest. At least he got a Benz Micro LP! There are many plain simple thieves or scammers on AA outthere selling thin air (have cought one selling Nordost Frey, he wanted to rip me off $500).

>This thread is an example of one!
>Why do so many used cartridge ads state "used only 100 Hrs"?