2. analog
  3. 1279934759

HK t-60 motor mounts loose?

Hi. Recently developed an interest in TT's. I have about 10 vinyl disks I'd like to transfer to CD. Last time I had a turntable, I didn't know much and didn't have the internet for help. I bought a Harman Kardon T-60. Had one 25 years ago. When the platter is removed, motor mounts are exposed which are three screws damped with rubber washers. They are loose, and I'm wondering if they should not be snug. I tightened the screws which bottomed out without snugging up the motor shaft. Does anyone know if it is ok like this or if I should shim it with rubber washers to make it snug? Lynne
arnettpartners
skriefal
20 posts
 
I believe you're referring to the screws for adjusting the suspension. These should be adjusted so that the bottom of the platter floats about 4mm about the surface of the turntable base (when the mat and stabilizer weight are sitting on the platter) and so that the platter is level at all points.
arnettpartners OP
312 posts
 
I'm referring to the three little screws around motor shaft which is suspended in the base. The motor shaft is not snug. I can move it vertically and laterally. The turntable works and the motor is quiet. Maybe if it works don't fix it, or maybe the motor capstan should be snug. I can't figure it out. Lynne
driver's avatar
driver
750 posts
 
Hi Lynne-I just checked mine & they're tight. There is one big "washer" that sits on top of the motor. I'll send you a pic. Jeff
arnettpartners OP
312 posts
 
Sorry for slow response. Thanks, Jeff. Good info. Lynne
More to discover