VPI bearing oil/grease?


I know this has been discussed and forgive me but I'm a little confused. Most of my confusion is from talking with Mike at VPI. I called VPI years ago to ask what type of lubricant to use, the answer was white lithium grease. ( no mention of any of this in the owner's manual) After my bushings were replaced a few years later with bronze, I inquired as to what oil/grease was recommended. The answer was 40W oil. After reading other posts here, I've read that Mike has recommended Mobil synthetic, I don't ever recall them recommending VPI bearing grease to me or anyone. I'd like to get a definitive answer from VPI users here. Thanks.
128x128slaw
Dover,
I remember you mentioning it, perhaps even in this very thread, but I wonder how much of an issue it is for a turntable bearing where the contact surface is so small, as is the amount of the lubricant used. The very lubricant VPI recommends and uses contains PTFE as well.
Frogman: No, not the Royal Purple. It seems a little higher viscosity and in applying it, feels more stable. I used it my first round for about 7 months, looked at it and could not notice any breakdown at all. In that time, there was no noticable increase/decrease in platter rotations after turning the motor off as I've experienced in every other lube I've tried. A slight sonic improvement over the white lithium I was using also. I use a ceramic ball bearing.
Re Slick 50, it took me forever to get the sludge that stuff left behind out of a TNT-2 bearing well.
Slaw, thanks for the clarification. Earlier you said that you agreed that the sound was leaner with oil vs lithium grease. I also noticed less-stable pitch with the grease; the main reason that I stopped using the grease. You mention that the DuPont grease yields an improvement over the lithium grease. Is the improvement related to tonality (leaner/weightier) or to speed stability? Thanks.