Albert Porters after market panzerholz plinths


I would like to hear from anyone that has purchased a panzerholz plinth from Porter Audio or a panzerholz DIY project.
Reading through all that I could find on this subject it's obvious Mr. Porter did his home work on his design.
My question to those of you whom refurbished, replinth and rearmed some of these direct drives has it advanced analog playback for you?

David
dbcooper
Dear Mikelavigne: We have to remember too that in the case of SP-10's or EMT these TT's were designed for Radio Stations/broadcasting more than to home audio systems.

Nice to hear that I'm not totally wrong about my thoughts on a nude ( non casework. ) SP-10 as a improvement.

regards and enjoy the music,
Raul.
Raul,

to be clear; my comment on the nude (original case-work removed) SP-10 Mk3 referred only in the context of installing the nude SP-10 Mk3 inside a custom plinth.

possibly that was inferred by your comment;

Nice to hear that I'm not totally wrong about my thoughts on a nude ( non casework. ) SP-10 as a improvement.

but that was unclear.

you could be referring to a nude SP-10 with no plinth. in that case, although i have not listened that way myself, i would be skeptical it would be optimal.
Dear Mike: No, I'm refering almost on what you posted about nude. This is what I posted in my firsat post in the thread:

++++ " Even seems to me that my SP-10s and Denon's could perform even better with out its metal bottom cover. I don't try it yet but maybe is time to make this test and see what happen. " +++++

Regards and enjoy the music,
raul.
Raul,

ok, i get it about what you were referring to.

OTOH it's clear we are not referring to the same thing at all.

you are mentioning about the stock SP-10 and removing the bottom-plate of the stock case-work in hopes of improving performance.

i am referring to completely removing the case-work and installing the motor and platter inside a custom plinth...and even that point is only related to the Mk3 due to it's considerable torque.

so my comment about a 'nude' SP-10 does not support your comments. they are related in a round about way but i don't share your viewpoint although it would not greatly surprise me if removing the bottom of the stock casework might be better. although i think it more likely that removing only the bottom plate would cause the remaining casework to resonate more.

i don't mean to be argurmentative; i'm simply trying to make sure that my intended meaning is clear.
++++ " Even seems to me that my SP-10s and Denon's could perform even better with out its metal bottom cover. I don't try it yet but maybe is time to make this test and see what happen. " +++++

Regards and enjoy the music,
raul.

Mike is not suggesting running the Technics MK 3 nude. His comment does not support what you've been pressing since the beginning of this thread.

One Technics MK3 renovation by Dobbins removes the MK3 top cover with speed switches (which is often damaged) and puts the rest of the table into his heavy plinth. Speed change is still accomplished at the motor controller.

I leave the cover and switches and support the entire works with a heavy brass rod attached to an iron block fastened to the chassis with stainless steel. This mechanism locks down any vertical movement and flex while absorbing motor vibration.

I have no doubt Steve has addressed this problem in another way and gets excellent results. With either method, both of us and most others such as the famous original constrained layer MK3 plinth by Akito Knita rely on multi laminations, mass and constrained layers to bring out the best performance of these powerful tables.