VPI Classic hum

Still no hum on my Classsic rig. The only thing I hear is my wife screamin' to turn the music down. LOL

Bifwynne: Mine didn't, too, at first. I think not every unit was plagued by this issue. If yours is working fine, I envy you, I still love the Classic's looks and sound.

Mine didn't at first, but it does now. Again, if you never ever heard what I'm talking about, you wouldn't know that it's there. For the most part, it's covered up by the music. It's only apparent when you are listening to the table through headphones. However once you've heard it, you can pick it out without fail.

Bassraptor, thanks for the info about the platter/bearing interface. I'll be keeping my platter, whole arm assembly, feet and transferring them to the Aries 3. Let me know If you come up with any additional info.

M~

For those of you who are suffering in silence. Get the following: Danco #36 O-Ring pn#96750 $3.00 and Surface guard felt washer kit pn#9425--- $1.96 from Home Depot or where ever.

1. Put the Danco washers under the motor around the mounting screw holes. The motor will rest on the washers.

2. Take the smallest felt pad and place them on top of the motor felt side up, midway between the mounting holes.

3. Tighten (just snug) everything down using a star pattern.

Why this?
Because it helps to isolate the motor.
It's cheaper than buying a 300RPM motor ($140+ shipping.
It works... to a point.

If it doesn't work, the washers and felt pads make nice Xmas gifts.

M~

Had a similar problem with a VPI Scoutmaster using a Dynavector 20XL along with a Cayin Phono One preamp. Replaced my Monster Cable interconnects with VPI shielded cables. Connected the ground wires to a water pipe. Hum problem disappeared.