2. analog
  3. 1301256637

VPI Scout - slow speed , help ?

Hi

I've recently purchased a KAB speed strobe which has indicated that my Scout is running very slow (notches moving counter clockwise); over 100 notches in 60 seconds.

I have the newer black belt with unknown time on it; I've cleaned the belt, motor grooves and platter grooves. I get power from a dedicated 15amp plug, through an Audience AR-6 conditioner and stock power cord to the motor. I've tried using different notches on the upgraded 300 rpm motor pulley, with little effect.

I suppose the cheapest experiment is to buy a new belt, and lube the spindle bearing (for which I'll have to purchase oil) and see if that changes things. Short of buying the VPI SDS, are there any other actions which may help here for little money? Perhaps a used Variac would essentially do what the SDS does?

Your constructive feedback is appreciated.

Regards,

Bryn
bshapperd
bshapperd OP
84 posts
 
Ok, the platter is consistently measuring fast, now. I've taken measurements with the motor plugged into: a different circuit; wall receptacle of the dedicated 15amp; the power conditioner, all with the same results. I've tried using different steps on the pulley with no noticeable change. I've tightened up the set-screw on the pulley (which was loose) and used a 45 lp on the platter to replicate stylus drag.

I'll try measuring the speed of the platter at different times of the day, but as others have mentioned, voltage should not effect the platter speed?

Ok, new thread " VPI Scout running FAST, help?"

What now?
czbbcl's avatar
czbbcl
1,752 posts
 
Have you asked VPI ?
darkj's avatar
darkj
150 posts
 
I'm not sure how familiar you are with your TT. Do you know that you can vary the speed in small but noticeable increments by moving the belt up and down on the spindle? The larger part goes faster, the smaller part slower.

Just checking - it would suck to go through gyrations and miss this important detail.
czbbcl's avatar
czbbcl
1,752 posts
 
Is the speed varying or is it consistantly fast ... Maybe a defective pully if it is consistantly fast... Just a thought.

Chuck
marakanetz's avatar
marakanetz
5,473 posts
 
One of the ways I've checked my turntable speed was with... Guitar Tuner.
I perfectly tuned my guitar and followed solos and chords of few bands I know and figure out that i'm out of tune from original recording by approximately 1/4 of a tone up.
That signalled me that my turntable belt got thinner and longer needing replacement.
Also you can play in unison same digital version of recording through your computer and see which one 'runs' faster. If everything is in-tune and/or runs with same speed than strobe is wrong and needs moneyback or free replacement.
The other suggestion is to realy check if you're using original VPI belt and if not, you'd better order it.
More to discover