Nottingham spacedeck motor - driving me crazy

Thanks, Rob. You are most likely correct. Fletcher's idea of how to use the motor was closely allied to that of Lloyd Walker, except Lloyd uses a much heavier platter than did any of Tom's designs (well, never saw an AnnaLog or a Dias in the flesh). I never experienced this particular issue with my Hyperspace. Occasionally I noted that the motor had crept too close to the platter, but it still worked fine to bring it up to speed. So, why does this Spacedeck work fine at 45 rpm but not at 33 rpm? I would think that belt slippage would be a factor at either speed.

45 RPM is harder for the motor to pull than 33 1/3, like trying to get your car moving in 2nd gear instead of first. If it will work at 45, the problem is not the motor.

I suspect that the reason the belt doesn't slip at 45RPM is because the 45RPM pulley has a larger diameter than the 33RPM pulley. Since the grooves for both speeds on the Spacedeck's platter are the same diameter, the belt must stretch to accomodate the bigger pulley. That stretch probably means that the belt is pulling "harder" on the 45RPM pulley than on the smaller one. The distance between the motor and platter seems to be critical. I have a PDF copy of the NA dealer manual and it calls for 6mm between the two pieces.

One other thing to check: due to its weight, the motor sometimes will slip down in its pod over time. When that happens, the grooves on the pulley no longer line up with the grooves on the platter.

Good point, John. I'd forgotten about that NA motor quirk. Here's what the dealer manual says about the motor height: "The motor height is adjustable and it is important to line up the grooves on the pulley with the grooves on the platter. Make sure the table is leveled first. If you need to raise or lower the motor, do so by pushing on the motor itself. It is snug in its housing, but it will move."

You shouldn't need to loosen the screws holding the motor to the housing to do this.