2. analog
  3. 1313617416

CJ PV-10 no sound

I installed a couple of GE 12AT7WA's (bp triple mica, aquired on E-Bay)into my CJ PV-10 today, and as soon as it came on, snapping sound and a hum. Now, no sound coming from pre-amp. It appeard as if one of the tubes shined brighter than it ought to prior to this happening. I'm going to go and get a new fuse to rule that out, but it looks OK. (BTW, so much for a the tube tester. Tested very good, no shorts!). On a seperate note, if I'm not able to get it fixed right away, I've tried running my NAK 670zx directly to my Classe 15 amp, and running my X-Ray CD player through the cassette deck. Sounds great (although I ALWAYS miss my tube sound). Any problem with this? Thanks
countryjazz2
countryjazz2 OP
17 posts
 
Yes, I put the old tubes back in. I also replaced the fuse. No sound. A bit of a pop and hum after about 20 seconds (when it would normally come on, then total silence).
mofimadness's avatar
mofimadness
4,974 posts
 
Sounds like you had a faulty tube that took out a resistor or diode. Probably need to send it back to cj for service. Bummer...sorry.
countryjazz2 OP
17 posts
 
What's really frustrating is that I recently bought an emissions tube tester, and it showed the tube to be good (with no shorts). So much for that...
hifihvn
943 posts
 
Emission testers don't give the results as good as a good mutual conductance tester. Some miss some of sections of a tube. But a good mutual test can too at times. Test the other tubes first just in case one of them let go. It sure can save the trouble. One may have let go, do to the different voltages in the preamp, from the new tube drawing more current if it is, or is not shorted. Odd things happen.
detredwings
162 posts
 
Since you have no sound from both channels? I would think your problem is with the power supply. Same supply for both left and right channels. If you have a phono section it also has one for it. If your tubes all light-up, then I would bet your B+ went out. Probably one of the regulators. I think you will need to send it to a shop. They are not difficult to work on.
More to discover