Turntable speed accuracy

Dear Frogman: We have to take care about. Unfortunately no one of us have control over the recording proccess where happen " terrible " things that " disturb " ( for say the least ) not only what you are pointed out but the " original " essence of the music.

We can't restore what already were degraded on that recording proccess but at least we can take care that that degradation be the lowest one and certainly the overall TT speed subject is vita. As I posted:

+++++++++ A TT exist because the LP needs to spin for we can listen it and has to spin always at 33.1/3rpm or 45rpm : period. " +++++ NO excuses here.

Regards and enjoy the music,
R.

Dear Dougdeacon: ++++ " concluding that idler wheel/rim drive designs are inherently better than BD's would be going too far. We've had such a design in our system, made by Teres, and it was audibly inferior to our carefully worked out BD. Implementation is always critical and individual cases may trump general rules. " +++++

what do you mean with this? that Paul and you listened to two TTs bis a bis with similar tonearm/cartridges at the same sessions/comparisons?

I know both of you and I have no doubt on what you posted it is only for I can understand how that comparison was made.

In the other side, implementation as you said is critical on any audio device design or on tests as the one you mentioned.

Regards and enjoy the music,
R.

Doug, what was the nature of the Teres fix? Did they increase sampling or resolution of regulation or something else?

what do you mean with this? that Paul and you listened to two TTs bis a bis with similar tonearm/cartridges at the same sessions/comparisons?

Fair question, Raul.

One TT, one tonearm, one cartridge, everything identical except the drive systems. We were comparing our tweaked BD to the (then new) Teres rim drive. Switching from one drive to the other took < 30 seconds so it was easy to compare, far easier than comparing cartridges or tonearms.

Result: we kept our BD.

FWIW, most who made the same comparison on their tables preferred the rim drive. However, those people weren't using our belt tweak because we hadn't published it yet, so their BD wasn't performing like ours. The two people to whom I provided tweaked belts also preferred the BD to the rim drive.

Implementation, implementation, implementation. :)

***

Tdaudio,
The main problem turned out to be intermittent failures in the motor brushes. Very difficult to diagnose. After months of experimentation/verification, Teres found that gold brushes eliminated the problem and performed for the long haul. Ours is still working fine, quite a few years on.

Secondarily, Teres tightened the correction threshhold of the motor controller by one order of magnitude. Our platter speed now drifts from 33.33 (45) rpm just 10% as much as it used to before the controller alters voltage to the (DC) motor.

This improvement was visible with a good strobe if you watched for some time, but not really audible to me. One would need absolute pitch sensitivity to hear it.

Dougdeacon: "Implementation, implementation, implementation. :)"

I love it when I see people doing experiment like that.

My friend owns one of the earliest version of Teres turntable before it went commercial. His motor failed couple years ago so I sent him a Papst motor salvaged from the Empire 208 with pulley diameter slightly tweaked to get accurate speed. It worked well and liked the sound and used it for a more than a year. I suggested him to try driving the Teres platter with a Technics SL-M3 direct-drive turntable via VHS tape. After some tweaks he liked it even better than the Empire that it's quieter and "overall sound wise, image is focused and sharp, more forceful with muscle, very nice." Of course, the downside is that the whole set up takes up much bigger space.

Yes, it is indeed quite easy to tell the difference when you only change the drive system. People should try something like this with a belt drive table just to get an idea how much the sound can change with a different motor. It's all reversible so it's harmless. Try it. You might like it. :-)

_______