Turntable speed accuracy

Dear Thuchan, I just this past month ordered the bearings for my new turntable design and the costs are - with a limited edition of 12 units for 2012 and 2013 - USD14,800 + 19% VAT for the bearing alone (no joke - for each single bearing).
But then this bearing is a custom-made bi-planar air bearing of outstanding precision, capable to lift and spin a 110 lbs platter with ease.
If one want to go all the way it get's expensive.
But there are many good standard bearings out there, for far less money and of high quality.
Cheers,
D.

Hi Dertonarm, how in the heck can a bearing for a table cost so much?

Dev, Just read what Dertonearm is asking that bearing to do. (Did you take note of the 110-lb platter?) Then imagine the special tooling and labor required to make the bearing in very small numbers. Then you will understand the cost. Based on typical ratio of parts cost to retail price in the audio business, DT's turntable will have to cost around $70K, just to justify his use of that bearing.

Hiho, I am actually glad I did not know all those details about Papst. I have enough useless information cluttering up my mind already. Sherlock Holmes told Watson that the reason he did not know about Copernicus (or some other well known related body of knowledge) was that he had otherwise to keep in mind the appearance of the ashes and the distinct odors associated with 170 different kinds of pipe tobacco, in order to do his sleuthing. I have never owned a tt with a Papst motor, and I don't aspire to, so no need for me to know anything more than what I have learned by casual reading.

I and several others have been waiting for nearly 2 years for Mark Kelly's motor controller for Garrard and Lenco. I am not holding my breath. This is not to say that Mark is not a completely honorable and brilliant guy; he just has a lot on his plate to distract him. It will be worth the wait, I am sure, once it is done.

Lewm: "no need for me to know anything more than what I have learned by casual reading."

That's very zen. I need to do that myself. Bill Belichick has a sign at his team facility that says "Ignore the noise." Good advice.

_______

Hi Dev, the bi-planar air bearing for my turntable in the 1990s was only about half the cost of this new one. But this new one has much tighter tolerances and will do the same job with 1/3 the air volume of the former.
In all engineering the cost/performance ratio becomes a steep curve towards the most tight tolerances, as the manufacturing effort and production reject rate rises in a much higher rate than just proportional.
As said before - there are a lot of good quality bearings out there for a fraction of the costs, suitable to provide very good bearing for a high end turntable.
The turntable using this bearing ( plus the USD3500 dental/medical grade compressor needed to run it ) won't ( can't ...) be a commercial product anyway.
Cheers,
D.