Sarcher and Pryso, Albert is ecstatic about the new modifications, but he really did not know much about what was done. I then talked to Bill about it. Mostly it is about dampening vibrations and firming up the stator supports. Bill notes that as the servo system corrects for speed errors, some of the energy of the motor is used up in micro movements of the stators, predicted by Newton's Third Law (For every action, etc...) (Ideally, all motor energy would go into moving the rotor/platter.) These tiny wiggles of the stator then in turn produce a tiny correction error sensed by the servo, which senses the fact that some of the torque went into moving the stators instead of the platter. This begets another correction from the servo. And so on. With the modification to the stator mounts, there is less energy dissipated in moving the stators, more precise speed correction by the servo, and far fewer events that trigger the servo. Everything gets even smoother than it was. There is also some work done inside the PS, about which I know nothing. Anyway, Albert likes. I will get it done, but the cost is $1200, so I am waiting a bit before I can commit those bucks.