Amount of AS is necessarily a compromise, but with a pivot type arm there's going to be skating. Amount of skating depends on more than just VTF. It increases with stylus velocity and steeper offset angle. It is caused by offset angle - the plane of the cantilever is extended off to the side, rather than aimed at the pivot as in a linear type arm.
So set your AS for "normal" loudness of most of your listening fare, not highest velocity on a test record. Offset increases as the stylus nears the center of record. Too little AS could add to inner groove distortion. Amount of AS is a compromise, but not a myth. Channel imbalance is readily seen on a scope or with newer software available. Carts with long cantilevers - skating can be observed visually if viewed from directly in front of cart while playing. Either the cantilever is almost centered relative to the body, or it's off to one side or the other.
So set your AS for "normal" loudness of most of your listening fare, not highest velocity on a test record. Offset increases as the stylus nears the center of record. Too little AS could add to inner groove distortion. Amount of AS is a compromise, but not a myth. Channel imbalance is readily seen on a scope or with newer software available. Carts with long cantilevers - skating can be observed visually if viewed from directly in front of cart while playing. Either the cantilever is almost centered relative to the body, or it's off to one side or the other.
