I am curious about wall mount shelf. My apartment has solid concrete floor with tension cable runnig through them. The floor is very solid with a layer of MDF and solid oak floor on top of concrete layer and is supposed to support about 400 kg per sq meter. The stereo equipment is placed near outwall of the apartment which is non weight bearing wall with windows and basically a brick wall. In this case, the floor is much more solid than the wall in my opinion. Foot fall is never a problem. In this case, would I still expect the wall shelf to be more benefitial? The factory bench/granite top that I used weight in at almost 100 kg.
TW Raven Owners: Set Up Questions
Through the magic of sweet talk, I turned my Orbe into a Raven and mounted my Graham 2.2/Benz LP.
I am looking for a isolation base for the Raven. I have a 1 3/8" piece of granite coming soon so I can ditch the MDF I use now (a temp. meas.!) Symposium, SRA, HRS, etc., can anyone share their experiences with isolation bases? I saw the thread about loosening the Stillpoints.
Initially I had an issue with using the rough side of belt. The belt shimmied up/down on the pulley at a specific spot on belt. Also, the speed fluctuated and I could never get it dialed in with the PSU. So, I went to the smooth side of the belt and then raising the back side of the motor (unscrewing one of the isolation feet) slightly moving the belt down from "center" on the pulley. This moved me from 33.2 to 33.3 and I have no more belt shimmying and the speed is rock solid.
I'd appreciate any tips/tricks etc.
I am looking for a isolation base for the Raven. I have a 1 3/8" piece of granite coming soon so I can ditch the MDF I use now (a temp. meas.!) Symposium, SRA, HRS, etc., can anyone share their experiences with isolation bases? I saw the thread about loosening the Stillpoints.
Initially I had an issue with using the rough side of belt. The belt shimmied up/down on the pulley at a specific spot on belt. Also, the speed fluctuated and I could never get it dialed in with the PSU. So, I went to the smooth side of the belt and then raising the back side of the motor (unscrewing one of the isolation feet) slightly moving the belt down from "center" on the pulley. This moved me from 33.2 to 33.3 and I have no more belt shimmying and the speed is rock solid.
I'd appreciate any tips/tricks etc.
- ...
- 49 posts total
- 49 posts total