2. analog
  3. 1350320370

VPI Platter Spinning SLOWLY

I've tried two different lubricants (Super Lube and Shimano Dura Ace Grease) for my VPI Classic 2 platter and it still does not spin properly. I removed and re-applied grease and it spins fine for about 5 minutes, then it slows down immensely. If I remove/re-install the platter, it spins smoothly again but only for a short period of time. Anyone experience this before and know a fix? Thanks
jyoungpark
brf
1,715 posts
 
How much grease are you using? You should be using a very small dab on top of the ball bearing only. Too much grease with an inverted bearing with a tight tolerance may cause it to bind.
jyoungpark OP
17 posts
 
@Brf
Just a dab. Then I distribute the grease around the bearing and on the spindle.
pbnaudio's avatar
pbnaudio
1,613 posts
 
Have you cleaned out the female part of the bearing as well, grease can get stuck between the two bronze sleeves there. From your description it sounds like you have too much grease. I use Viper Lube by Locktite item # 36784

Best of luck

Peter
More to discover