Kevin Carter of K&K Audio has a prototype PS that has two outputs with phase angle adjustment. The only thing holding him back from releasing this as a kit is the need to assemble one so he can write up the instructions. If enough people were to email him that might provide the motivation to finish this project. The price of the kit should be reasonable compared to commercial units and it should be sonically superior to all the single output PSs out there.
High quality AC turntable motor
I am looking for a high grade AC motor for my Townshend Elite Rock turntable.
The current motor is specified to run at 110v 250rpm. I reckon that it's got very little torque. I have considered the phillips and the premotec - but they appear to offer no real alternative so far as specs are concerned with what I have.
I have seen a couple of motors on the RS Online website by the likes of Berger, and Crouzet. The Crouzet motor intrigues due to it's high torque rating. my concern is whether or not it is noisy, and vibrates a lot.
Does anyone have experience with these motors? or does anyone have any suitable suggestions?
I intend to try out a few different power supplies on the deck at some point.
The current motor is specified to run at 110v 250rpm. I reckon that it's got very little torque. I have considered the phillips and the premotec - but they appear to offer no real alternative so far as specs are concerned with what I have.
I have seen a couple of motors on the RS Online website by the likes of Berger, and Crouzet. The Crouzet motor intrigues due to it's high torque rating. my concern is whether or not it is noisy, and vibrates a lot.
Does anyone have experience with these motors? or does anyone have any suitable suggestions?
I intend to try out a few different power supplies on the deck at some point.
- ...
- 51 posts total
- 51 posts total