Halcro,
Yep, but that won't happen. A lot of new ones pass, but the surprise is which ones.
Some old ones don't pass, however. I built a DIY turntable around eight years ago that started life as a Lenco. It runs a little less than 1/4 RPM too fast no matter what I do, so after a frustrating hour wasted I quit tinkering with it. I could never get the wheel placed accurately enough to correct the issue, as minor as it may be. It's dead on according to the KAB Speedstrobe, so I suppose it is close enough. Maybe I'll revisit it someday.
The real problem is with those turntables out there that do not keep a consistent speed. It is one thing to have an ever so slight speed issue that is evenly paced, but quite another when it varies, especially if it varies abruptly.
.
Yep, but that won't happen. A lot of new ones pass, but the surprise is which ones.
Some old ones don't pass, however. I built a DIY turntable around eight years ago that started life as a Lenco. It runs a little less than 1/4 RPM too fast no matter what I do, so after a frustrating hour wasted I quit tinkering with it. I could never get the wheel placed accurately enough to correct the issue, as minor as it may be. It's dead on according to the KAB Speedstrobe, so I suppose it is close enough. Maybe I'll revisit it someday.
The real problem is with those turntables out there that do not keep a consistent speed. It is one thing to have an ever so slight speed issue that is evenly paced, but quite another when it varies, especially if it varies abruptly.
.