2. analog
  3. 1354716369

Soundsmith cartridge, opinions appreciated

Does anyone have any experience or feedback on the Soundsmith SMMC4-ST
cartridge? I am looking for a high compliance cartridge to match with my Pro-ject XpressionIII turntable which has a low effective mass arm. I am running a Denon DL-110 right now and have loved the sound for many years but I think the low mass carbon fiber tone arm may not be the ideal match for the lower compliance Denon. Sounds a little thin on top and doesn't have the bass drive it used to have. Any suggestions, comments, observations are appreciated
mmt
mmt OP
60 posts
 
Bpoletti, thanks for the reply. Question though, I suppose I can add mass with a spacer or weight at the headshell, which might require VTA adjustment which is OK but is it the best solution to add mass in just one spot (headshell) instead of across the entire arm? I added a 1 gram spacer initially but still with same results. I might be over thinking this though.

Sbrownnw- Ortofon is a little higher compliance than the Denon. Was the Benz an upgrade from the Ortofon?
bpoletti
1,556 posts
 
There are lead spacers that are available as well as heavier mountings screws. Sound Smith sells the mounting screw sets made from different materials that allow for the adjustment of mass.

Mass, as seen at the cantilever, can be placed anywhere on the arm. But adding mass at the headshell is more effective than close to the pivot.
sbrownnw
709 posts
 
The Benz, even though I only heard it briefly at my dealer, is an upgrade from the turbo MC-3.
bpoletti
1,556 posts
 
BTW, just a reminder that if you add mass to the arm remember to reset tracking force.
More to discover