Processor is Parasound C2. I had a Classe' SSP-35 mk2 then moved to the Classe' ssp-75 but had nothing but issues with it hence the "downgrade" to the Parasound that has performed flawlessly.
???Phono Preamp for Rega RP3 W/Elys2 ????
Just purchased a Rega RP3 with Elys2 and looking for reccomendations for a decent preamp. My system includes the following;
Paradigm Studio 100 mains and servo sub
Parasound preamp
Theta Dreadnaught Amp
Kimber Kable thruout.
Have been searching on line for suggestions. Currently considering Jolida jd9, Cambridge Audio 651p, and a few others. Tube vs SS??? Prefer to keep around the $500 ballpark. Thank you all for your opinions. Im a vinyl virgin and a bit nervous diving in.
Paradigm Studio 100 mains and servo sub
Parasound preamp
Theta Dreadnaught Amp
Kimber Kable thruout.
Have been searching on line for suggestions. Currently considering Jolida jd9, Cambridge Audio 651p, and a few others. Tube vs SS??? Prefer to keep around the $500 ballpark. Thank you all for your opinions. Im a vinyl virgin and a bit nervous diving in.
- ...
- 22 posts total
Ok, everyone has missed the boat here with suggestions....1st off the turntable is awesome.Bearing in mind the costs of the other components in the system and type, I fully recommend the Musical Fidelity V-LPS MKII at $200.00 it is a perfect choice for your system.It will out perform or work as well as all these others. Good Spinning! Matt M |
I have had my Jolida JD9 for two years now and love it. I had considered the Vincent PHO-8 with its rave review in TAS, but liked the idea of getting some tubes into the signal path. The Vincent distinguishes itself with a large, separate power supply. The Jolida has a similar-sized power supply in the corner of a single full-width chassis. I managed to get a demo JD9 for a little less than the Vincent. The Jolida lends itself easily to tweaking and mods. I swapped in NOS Sylvania Gold 5751s for the stock 12AX7s and put Herbies Tube Dampers on them. I also have a Zu power cord and the unit sits on Vibrapod footers. You can also swap out the opamps for much nicer ones. In most versions this is a pull/replace drop-in replacement with no soldering work. The other thing that distinguishes the Jolida at this price range is its wide range of adjustability for fine-tuning the cartridge load. It has three levels of gain for MM, HOMC, and LOMC. It has two levels of output as well. In between, it has a wide range of capacitance settings for MM and a wide range of resistance settings for MC. The only other broadly adjustable phono at this price range (that I know of) is the Musical Surroundings Phonomena II, but its minimum capacitance setting is 200 pF, a deal-killer for me. The Vincent has the standard 100 ohm input for MC carts and 47K ohm for MM carts. |
- 22 posts total