2. analog
  3. 1366575420

Herron VTPH-2 Phono Preamp

I have a few questions for those of you who own/or have owned the Herron VTPH-2 Phono Preamp.

1) If you have sold it.....what was it that seemed to be lacking that made you decide to sell it? What did you move on to?

2) If you still have it, what are its most enduring traits that you love about it?

3) Has anyone compared it to any of the Klyne phono stages and what were your impressions of the comparison?

Thanks much!
no_regrets
no_regrets OP
543 posts
 
Thanks again gentlemen for your replies. I was able to email a little bit with Keith today about his phono stage.

I'm currently using the Benz Ruby ZH which has a .7mV output and therefore would need to order mine with the 64dB of gain which uses 2 x 12ax7's, 3 x 12at7's.

Which cartridges are you all using with this phono stage?
czbbcl's avatar
czbbcl
1,752 posts
 
I use a Benz Micro Wood SL which is .4mv output.

Chuck
dodgealum's avatar
dodgealum
1,406 posts
 
I am using a ATOC9MLII. I don't recall the output but I am using the tube set in my Herron for low gain--mostly because I have very high efficiency speakers.
bpoletti
1,556 posts
 
ATOC9MLII should be a spectacular performer on the Herron phono stage. IIRC, it is the cartridge that Keith Herron uses to voice his equipment.

And yes, the VTSP-3 r02 and the latest version of the amps are wonderful. I was lucky enough to get that preamp just as the latest rev was being released and have a pair of latest mods of the amps.
teeshot
123 posts
 
I recently purchased the VTPH2 from Keith. I am using a cartridge with .28mv output. The 64db of gain from my VTPH2 is plenty in my system.
More to discover