2. analog
  3. 1396127849

Rega RP10 VTA shims

I am sure this applies to the RP8 as well. But I have an RP10 and bought two of the 2mm shims to accommodate the VTA of a Kleos cartridge. My dilemma is that the single shim does tighten the bass to where i prefer but the highs and mids drift from what I prefer. With both shims the highs and mids are, in my opinion, exactly what I want, but the bass control starts to slip away. Does any one know of a 3mm shim? I think that would bring everything into line. I will experiment with tracking force, but am reluctant to drift to far from 1.75 which was ideal on my old LP12. I looked at Acoustic Signature but this are drilled for the RP6 which uses a smaller screw. Also I am considering the Groove Tracer counterweight, but I really don't see that as the correct solution for this issue, but rather a tweak once the VTA is corrected. So my question is, anyone have an RP8 or 10 that has come across this issue and have you found a different supplier of shims for the Rega. I have thought about filing my extra 2mm down but realize I cannot maintain a perfectly flat surface.
128x128theo
mofimadness's avatar
mofimadness
5,258 posts
 
Try these guys:

http://www.soundsupports.com/page9.htm

If they don't have it, maybe they can make you one.
Post removed 
jcarr
382 posts
 
Dear Theo: The Kleos was designed to have a vertical height (headshell underside to stylus tip) of 17.377~17.48mm with VTF applied. Let's say 17.4mm. I believe that the Rega cartridges are 14mm high, and Rega's tonearms and shims are designed accordingly.

IOW, you probably need to bring the base of the Rega tonearm up by 3.4mm to make the Kleos level.

If Rega cannot provide a custom shim for you, I would bring one of your shims to a machine shop. Ask them to caliper the inner and outer diameter, then have them make up a custom shim of 3.4mm thickness (if the machinist can make 3.43mm thickness, even better).

If you have a range of tonearm shims made to varying thicknesses, say 0.3mm apart (or even 0.1mm if the pricing allows you to make 10 or a dozen), you have a fairly predictable method of experimenting with SRA. Shims of more than 3.4mm thickness will result in tail-up SRA with the Kleos, and shims with less than 3.4mm thickness should result in tail-down SRA.

Or as Elizabeth said, you could install the two Rega-supplied 2mm shims, then add an LP mat of 0.6mm thickness to take up the difference.

hth, jonathan carr

PS. When changing the tonearm bearing height, recheck the VTF and overhang, and correct them if they have shifted.
More to discover