Is this considered a "balanced" cable?

You should read the description of balanced circuits on this site.

http://www.balanced.com/faq/balanced.html

After reading that, it should be apparent that running a single ended cable (rca terminated) from a preamp without a balanced topology into an amp with a balanced topology does not result in a balanced circuit.

That question aside, all the other advice and comments above may drive you to try and use the adapters anyway. Dunno what the results of the experiment would be. Try markertek.com for the adapters.

BTW...

if you find out what the rotel actually implements behind it's balanced connections (is it actually a fully balanced topolgy), i'd like to know. :-) I was considering a pair of these as rear channel monoblocks in my theater.

Objective1...The term "balanced" should be reserved for wires. An amplifier circuit that has mirror image circuitry for inphase and inverted signal should be called "complementary". The push/pull output stage of an amplifier is complementary, regardless of the rest of the circuit. An amplifier with complementary circuitry can be driven by a single ended (unbalanced) signal...an inverter stage is included at the input. It is also reasonable to use balanced lines between circuits that are not complementary, but which include appropriate output and input circuitry. The balanced lines give greater imunity to noise pickup.

Where did this rumor get started that the merit of a balanced interface has to do with whether an amp is a "complementary" design?

Actually, a single ended output connected to a balanced input circuit may help an installation as the grounds between the two components is are not connected.

So have at it, give it a shot. You can get the cable pre-made with rca/xlr ends from a guitar store or Markertek.

steve

Eldartford, leme@lone.com

my bad.... i over simplified the conversation with my lack of full understanding(?)... sorry for muddying the waters...

I just hate to see someone ask a question that appears to have a simple answer, "If I use a rca cable with an xlr adapter going into the amp is it considered balanced?" ...and the person get a bunch of confusing conversation that doesn't actually answer the question.

Tigermark89 ... good luck. Hope the link to the BAT site helped.