THE LATEST---Gold plated fuses?

Uppermidfi, Tin_cup

I hate myself for drawing your interest in the power matrix, as I actually get them outside USA in the Far East. These are manufactured in the US, I understand, but I don't know where you can get them in the country.

What I know about the power matrix is little except it sound better than the Furutech and some other I have tried, albeit more expensive. My rememberance of past advertisement of the product being that they use precious metal for the wire and filled with RFI absorbing material. The product did not accompany any explanation and unlike normal fuse the Power Matrix is sealed and one cannot see through the inside.

I see if I can trace the contact details of the manufacturer and if success will post for information.

greeni - that would be great.

Just ordered a German fuse to go in my amp....for $25 I can't lose, will be fun to see if there is a change I like.
Larry

Rather than replace one's fuses with something that costs quite a bit of money ( for what it is ), why not try doing something to simply optimize what one already has? That is, remove the existing fuses and thoroughly clean ALL of the mating surfaces on the fuse & fuse holder. I will GUARANTEE that if the fuse has been installed for more than a few months of time, oxidation of the contact surface has taken place. Just pulling and re-inserting a fuse can increase conductivity and lower distortion.

A place that i used to work at some 20+ years ago was having problems with a machine. They called in a serviceman to check it out and he diagnosed the problem as low voltage coming into the machine from the wall. As such, the company invested in a "buck-boost" transformer and was going to have an electrician install it.

Before they called an electrician to have the transformer installed, i pulled the machine apart and cleaned all of the fuse contacts. I used a small brass bristled "toothbrush" that i brought in from home. After doing so, there was a reduction in current draw of appr 8 amps after cleaning.

Needless to say, this was a HUGE difference in power consumption and voltage sag. On top of that, the machine ran much cooler and more efficiently. We never had a problem with the machine ever again, so the buck-boost transformer sat in the corner for a couple of years collecting dust.

As such, do yourselves a favour and perform some basic system maintenance before investing in the latest tweaks and gadgets. I'm not saying that some of them don't work. What i am saying is that what you have can probably work a LOT better if you simply took the time to properly set it up and maintain it. A bit of elbow grease and some common sense can go a LONG way in most any situation. Sean
>

Sean is it your supposition then, that some of the new high dollar fuses sound better because the contact points have been slightly cleaned by installing a new fuse?