Speaker Cable Termination


Because I have owned Mag 3.6 for awhile I have opted to use bare wire at the speaker/amp terminals. Non-scientifically, it seemed to me that there was no need to introduce something into the signal path that was not necessary. I have used bare wire with Kimber 4TC for over 10 years. As I am looking to upgrade my speaker cable, it seems I now have to consider termination. I say all this to pose the question of termination vs non termination on speaker cable. Thoughts?
xagwell
Arni,
applying a silver solder to the ends of the bare wires makes no sencei since it decreases the contact conductivity.
The unit resistance of the solder is more than several times higher than any conventional conductor even with the silver content.
"11-17-06: Marakanetz
Arni,
applying a silver solder to the ends of the bare wires makes no sencei since it decreases the contact conductivity."

Marakanetz, I did not claim any benefits to this nor recommend it; I was just making an observation about pre- and past practice of a cable manufacturer that has actually discontinued doing this. My wording may have been off, I really meant tinning the ends (that is my recollection).
To me bare wire is really the best.Even if you order the cables a foot longer than you need and clip off 1/2" every year , you would grow old before the cables were unusable.
"applying a silver solder to the ends of the bare wires makes no sense since it decreases the contact conductivity"
You got to be joking, how much decreases in % ? Is there fact ? The solder acts like bonding agent to close all the air gaps of the strands to one solid wire for better conductivity. Look at all the circuits in all electronics what do the use to connect all the wires to?
I would think bare wire is the way to go, contact cleaner should work for oxidization but just buy and extra few inches on both sides and clip an inch off every 2 years.