Synergistic New Tesla Line...Any comments?

Leica_man, what power conditioner do you use? Or do you have enough dedicated outlets to plug all your PC's into?

Since I'm unable to run a dedicated line, I use the PS Audio Power Plant Premier. This assures I get continuous 120 volts. Therefore, my system does not degrade at certain times of the day. Also, I dont find it fatiguing. The T3 just did not work well on it. But the Synergistic Precision AC was much better on the PPP. The lost of clarity, air and high frequency extension disappeared when I switched the cables.

I may look into the Synergistic Powercell when more information is available.

Hey Joey,
Not trying to diss your power conditioner-everyone is entitled to their opinion. It's just that whenever I've tried the PS Audio products it's always been fatiguing to my ear compared to the direct wall connection-every single time.

I have two dedicated circuits with two duplexes each and a common true earth ground. That said I too am looking forward to the new PowerCell-if it works it will be the first line conditioner I've ever found to improve and not mask or "HI-FI" the sound of my system. For the record I've tried just about ever line conditioner there is from a design stand point and so far I don't like any of them but for different reasons.

Leica_man, thank you for the advice. I will certainly do the 96 hour test, or as close as I can make it :)
I am glad to hear of your positive experiences. I am going to start with the T3 and hope to eventually be able to move to a Hologram. I am so impressed with what Synergistic has achieved with the Tesla series.

How does the T2 compare with the T3 on a pre/CDP?

Hasse,
The difference between T2 and T3, and their sound, depends on the amount of current you pass through each cord. On high current demand components like power amplifiers, the T3 has more body and weight, especially in the lower registers and mid range, when directly compared to T2 in the same application. When I compared T2 to T3 on low current demand components like my pre amp, the T2 was more forgiving while the T3 was higher resolution with more detail and slightly more air especially in the upper registers. In medium current demand applications like CD players it's a toss up between the two-one will make music it just depends on the overall balance of your system and other cables in your system.

I find the T3 to be wonderfully rich and layered-especially in the mid range with a tube like quality when used on components that draw lots of current. While on my pre amp I found the T2 to have a special synergy with just the right amount of detail and texture and holographic sound staging. As good as the T3 was on my amp and CD player, I much preferred the Holograms but these power cords are at the top of the power cord food chain in performance and price. If I were not willing to spend this kind of money I would have been very happy with a full T2 / T3 system as both easily outperformed my prior and much more expensive power cords.