Speaker Cable Suggestion

Audphile1,

That's an interesting point on the interconnect. I do recollect that when I installed the Monster M950i Interconnects some years ago it was an upgrade to some older $40 monster cables. At 4x the cost, I did'nt notice a major difference.

These are newer components though so I probably do need to put some more thought on a better interconnect match.

As for the speaker cables, I'm looking for standard 8ft and hopefully spend no more than $500.

Thanks for the suggestions.

Mglennyc, I went from M550i to M950i and don't recall dramatic difference. Not the same going from M950i to AZ Matrix RefII though, where the difference is very noticable.
The soundstage just exploded with the AZ interconnects. And I still had the Monster M2.4s speaker cables!

The reason I suggested going with an IC change at first is because this is in the input stages to the amp. Changing the speaker cables will result in an improvement, but the new sp cables will only pass what the components before the amplifier supply through a set of M950i interconnects. So that is limited to the resolution of the M950i, which unfortunately is not that great.

If you are looking for an 8ft pair of speaker cables, at this price, attempt to find a used pair of AZ Satori Shotgun. If you are looking for smoother highs and increase in soundstage, the Satori is hard to beat in this price range.

I do not know what support/rack you have your system components on, and this could certainly have an effect on the highs and mids. Assuming that that is ok, or at least not significantly contributing to the sonic problems you describe, some past experience suggests that at least some of the mid-range muddle may be due to the IC. However, I would not accuse Monster ICs of grainy or metallic highs (unless suffering from corrosion / oxidation).

I would not immediately suspect the NAD CD player of the grain and/or metallic reproduction. To improve the midrange I would ensure the equipment and speakers are well setup, and try a different IC from the CD player to amp. You do not have to spend tons of money to exeriment: order an inexpensive pair from Signal or Audio Art or something. This would allow you to determine the effect on the sound, and you can always use it in a less critical area if you decide to get better ICs later.

For speaker wire, I would recommend Analysis Plus Oval 12. It is a good all around cable, is affordable, lacks any sins of commission, and would seem a good match to the rest of your system.

Glenn,

Thanks for the response.

The equipment is housed in an entertainment center that is for the most part solid wood. I think it took four movers to bring it in the living room. With the thick carpeting, all my books, leather sofa and curtains, I'm assuming the room is acoustically friendly. The B&Ws are on there designated stands and spiked into the carpet.

Since I only have the CD player and turntable preamp connected, its hard to mess this up.

Given three votes so far to focus on interconnects, that is exactly what I'm going to do.

Thanks again.

If you get good ICs, the next thing to further improve the sound is to get a good power cord for your cd player. That will further reduce the glare and metallic qualities. Try Audience powerChord. For a good pair of ICs and this power cord you will easily fit into $500.