Bi-wired vs Single Termination

if you go with a single run you will need a better jumper to get the best sound. Some would recommend a single run of better wire and others will recommend bi wire of a lesser quality (for the same price) The bi wire config will give better bass (usually IMO) just because of the greater cross section of wire

bottom line is you will get a million different answers it is best to buy used and try for yourself.

The signal sent from amp to speaker by bi-wire is full-range to both pairs of posts. What is split is the feedback from the speaker, particularly the woofer. The woofer's physical movement generates electrical energy that travels back toward the amp. With a single wire that energy goes into the crossover and you can have inter-driver inaction, potentially degrading midrange performance.

Good crossovers are designed to disapate this energy and don't need to be biwired. However, some speakers are designed to be biwired and will generally sound best that way.

I don't have any direct experience with your particular speakers. Maybe someone with that experience will comment.

Dave

Hey Smerlas,

Check out my Goertz Bi-wires over on Videogon, great cables at a great price!

http://cgi.videogon.com/cgi-bin/cl.pl?cablspkr&1210861200

-RW-

Figured I would get different opinions, I am looking at used the two cables mentioned are available here for about 1K used. I was hoping for someone who has similar speakers who might have tried both and what their impression was. Also came across a interesting comment from a Bryston owner about their 9GA speaker cables ... went something like if they are OK for studios then they are good for their set up ........... makes sense .... is 1K for speaker cables a diminished return over say the $250.00 Bryston speaker cable.

What length of speaker cable do you need? There is a pair of Jena Labs Symphony cables on Audiogon, 6ft biwire that are outstanding cables. I am not the seller but really like what these cables offer. What is the rest of your system? Solid state, tubed or a mix? Also, I would agree with Dcstep regarding the general question you posed. If you go shotgun, get better jumpers, otherwise biwire is typically a better solution for most speakers that are designed this way.