You should notice an improvement in sound quality. Honestly you could make your own PC's using Belden 14/3 or 12/3 shielded or an unshielded SJOOW 14/3 16/3 from Home Depot. An AC plug will run apr. $4-10 and an IEC plug $20 (Solderless) and one that requires soldering much less. Of course you could spend ALOT more. What I have done on some of my tuners is use an 18/3 shielded cord which I bought used for about $4 from my local computer store to great effect. Tuners only draw 10-20w. (On my Yamaha T-7 I harded-wired 16/2 unshieled SJOOW and it sounds fantastic.) Good Luck w/your quest. Bill
about to jump into the power cord foray
I am about to jump into the power cord foray. Since I’ve upgraded my IC’s and speaker cables most recently, I think the next step should be to look towards replacing the stock power cords. My system is as follows:
Dynaudio 52SE bookshelves
McIntosh MC2105 power
Audio Research LS-7 pre
Adcom GCD-600 cd changer
Lite Audio DAC 60 dac
Rotel RT-1080 tuner
Audioquest Diamondback & Kimber Hero IC’s
Kimber 8TC cables
I intend on putting IEC sockets on the A/R, McIntosh, and Adcom in the next week. If I could find a high quality changer, I’d probably dump the Adcom but I haven’t seen anything that’s really in my price range. Since I don’t have a new power or pre amp in the budget for the next 2 years, I plan on adding IEC sockets to the aforementioned devices. Will I notice any sort of improvement in sound quality, by going with Signal or Element cables with my current equipment? If not, should I look at a cable in the $100-150 range like the Virtual Dynamics Power 3 or VH Audio Flavor? I’m also open to any used cables on the site in the sub $150 dollar range
Dynaudio 52SE bookshelves
McIntosh MC2105 power
Audio Research LS-7 pre
Adcom GCD-600 cd changer
Lite Audio DAC 60 dac
Rotel RT-1080 tuner
Audioquest Diamondback & Kimber Hero IC’s
Kimber 8TC cables
I intend on putting IEC sockets on the A/R, McIntosh, and Adcom in the next week. If I could find a high quality changer, I’d probably dump the Adcom but I haven’t seen anything that’s really in my price range. Since I don’t have a new power or pre amp in the budget for the next 2 years, I plan on adding IEC sockets to the aforementioned devices. Will I notice any sort of improvement in sound quality, by going with Signal or Element cables with my current equipment? If not, should I look at a cable in the $100-150 range like the Virtual Dynamics Power 3 or VH Audio Flavor? I’m also open to any used cables on the site in the sub $150 dollar range
- ...
- 56 posts total
- 56 posts total