can biwire cables be used on a non-biwire speaker?

I guess I'm asking if I can just connect one pair of leads (high or low) and still get full range?

I know I can't connect them both.

I'm not sure how the bi-wiring on the bedrock works? Is the signal full range for both leads and just gets split inside the speaker? or does it get split inside the cable somewhere?

Al

Thank you! that's what I was trying to say... one of two pairs of leads going to the speaker would be left unconnected. It would just be temporary and I'd zip tie it back and wrap tape on the banana plug so it wouldn't accidentally short out.

I'm not familiar with the particular cable, but I'd feel certain that it does not contain a crossover network that would route different frequencies to one or the other pair of wires.

At most one pair of conductors might be optimized for higher frequencies, in some way, and the other pair for low frequencies. But those differences, if any, would be of comparable magnitude to the kinds of differences that cables normally make.

If the two pairs of conductors differ from each other, I'd suggest using the low frequency pair, to assure adequate gauge.

Regards,
-- Al

Thanks Al

They are the same gauge I think, but I will use the lower freq pair. In face before I box the speakers up I might go ahead and do that just in case there are any differences in sound.

thanks again!

You're welcome! You undoubtedly realize this, but just to be sure, if you try it with your present bi-wire speaker terminals you'll have to jumper the high and low frequency speaker terminals together.

Regards,
-- Al