sound difference MIT ORACLE AC1 vs ELROD vs PURIST

Caliaripaolo, I have my rack about 1 ft from the wall.
I had to carefully bend and loop the PC to make it work.
I'm going into a balanced cond. so it was a little easier.
If your going into the wall, you might need to kill the breaker to the wall output and take the recepticle out and flip it over to make the termination line up.
Sometimes the IEC and the three prong plug are upside down from each other and wont line up to the wall.
They are a patient tester. It will be worth the effort.

thanks Zmanastronomy. I see in your system as you bended the PC. I will try to carefully bend the cable. I was not sure to make the correct action with the risk of damage. I ordered a 20A to 15A plug in WOODOO adapter to fit the distributor input. Has someone used it?

The best bet is to have at least 1 foot of clearance behind your racks to allow for the stiffer cables as has already been pointed out. Bend the Elrod cables slowly into the alignment you are looking for and then make sure they are supported at various points along the cable length including coming out of the back of your components using a thin board or whatever gets the job done. They take a bit to settle back in sonically after you bend them but assuming they do not move after that and you have them properly supported, they will warm back up and sound great.

I added a third elrod cable (power to Berkeley DAC). I can confirm which, in my system, it seems that the interaction with the others Elrod's enhances the properties of a better soundstage and presence of instruments on the scene.

I echo Caliaripaolo. I put an EPS-3 in place of the 2 on my amp and there was a noticable improvement in energy, attack and bass.
I then put the EPS-2 on my CD players tube output stage and was blown away by the soundstage improveents.
I'll be getting another 3 Fri. to go between my balanced cond and the wall.
That make two 2's and two 3's in my system. They are definately accumulative.