Help with speaker cable under $500 for new system

Regarding the several recommendations that have been made for Clear Day: Assuming the goal is for the cable to behave in as neutral/accurate a manner as possible, and given the 12 foot length you require in one channel, I would caution against using anything less than the double shotgun version.

For example, the single (two conductor) configuration is described as consisting of a single pair of 24 gauge silver conductors. In a 12 foot length, and given the 8 ohm nominal impedance of your speakers, the resistance of that cable would reduce the effective damping factor of your amplifier from its specified value of greater than 1000 to about 14.

Regards,
-- Al

Thanks Al, I will keep that in mind for sure. I notice that Morrow has 25% off on their cables at the moment, but you would still go with Clear Day?

02-04-15: Ptolomy2
... but you would still go with Clear Day?

I'm not recommending for or against the double shotgun version of Clear Day, as I have no experience with it. But I am cautioning against the single and shotgun versions, assuming as I said that the goal for whatever cable is selected is for it to behave in as neutral and accurate a manner as possible. The gauge of those two versions is simply too narrow for a 12 foot length, IMO, even after taking into account the slightly better conductivity of silver vs. copper.

Good luck. Regards,
-- Al

I second the Cerious cables. I use an 8 foot set in a tube system w/ Wilson Witt II's.

To the OP, do any of the systems of the people recommending the Clear Day cables look similar to your system? If not, then why would you think those cables would work in your system? Cables are very system dependent.