Sound Application line conditioner experience?

Just found this thread. I have owned multiple Sound Application units, have always found them cleaner and faster than other ac devices, and still remember that one saved my entire system when it was on and lightning struck my water heater a mere 5 feet from my system. What always troubled me about SA was Jim's constant improvements. Anytime you jump on board, you can be confident that shortly thereafter there will be a new model and in my experience, the new model will be better.

Presently, I have once again gone down the path of using a "filtering" box, if you want to call the Acoustic Revive RTP-6 such a device. I really wonder what my sound would be like to have a RLS-1 to compare with it. Or perhaps to install prior to it. Maybe someday!

Teck5 or anyone that can help:
I would like to know the sequence of plugging components in. I just purchased an RLS on Audiogon and am very impressed. While there was only a slight improvement in background noise and imaging - the top end REALLY became much clearer and lifelike.
I'd like to know the sequence, since we power our Pass XA amplifiers, Oppo 93, Meridian 861v6, 800 and HD621 and LG 60 Plasma TV in our RLS. BTW - we use MIT Oracle cables and Watt Puppy speakers and Jim's RLS took our system to the next level!
Thanks in advance for any help you can offer, Thomas.

Tjassoc, the sequence is always the same. Big amps on last and off first.

Hi Tjassoc,
Depending on the Sound Application model you have and in reference to the where the power cord plugs into the unit:

For the Digital side:
- digital source closest to the power cord
- and then remaining digital items after that

For Analog side:
- pre amp first or closest to power cord
- then remaining analog components

I suggest you plug your amp direct to the wall.

Hope it helps.
Teck5

Teck5,
Thank you for your help. We're enjoying our Sound Application and will reconfigure ours to your/Jims recommendation.
Kindest regards, TJ Foti.