Audio and HT - Finding Balance


Long time lurker with a first time post.

The question of the day-month-year (and the one that I find myself very interested in at the moment) seems to be this:

(1) I've got a great audio system and now I'd like to add HT to the mix. What is the best way to keep my great audio set-up (and the flexibility that I've grown accustom to) and add HT? More specifically, if I add HT what is just ok, what is good, and what is great?

-or-

(2) I'm (re) building a system. I'm really interested in great music reproduction, but I would also like HT. Again - what is the best way to add HT? What is just ok, what is good, and what is great?

Two months ago I was in category 1. After a house fire, I now fall into category 2.

I've seen this question asked 100 time in many specific posts, but I'm looking for a general discussion.

Frankly, I'm lost. Thanks in advance.
dustyr
Start with the hippocratic oath: "first, do no harm."

If you really want to keep a high-end audio setup and add HT, you should seriously consider front projection if your room allows. I've been room-constrained now for 4-5 years, but am preparing to take the plunge. With low cost DLP projectors like the Plus Piano ($3K) and $1500 for a good screen, you can have a set up for not much more than the cost of a large rear projection set, that provides a BIG picture, without a large box sitting between the speakers that obstructs the soundstage. When I'm not watching movies, I plan to cover the screen with a wall-hanging quilt that will provide some acoustic treatment.

Also, look for a processor with an analog pass-through. Depending on what front end you have, you may not want to use the D/A conversion in a HT processor, unless you're buying a true top of the line model. Analog pass-though is becoming pretty common because of SACD and DVD-Audio, fortunately.

Do you have L/R speakers that are salvageable from the fire? If so, you need to select a center channel that matches very closelt in timbre - selecting one from the same manufacturer is almost a must unless you can do a lot of home auditioning.

Why don't you post waht equipment you're planning to use as the basis for the system. You'll have no trouble elicting lots of opinions! Good luck. - Rob
Focus on two-channel first and foremost. Once satisfied, add a subwoofer and tv (Plasma, or front projection would be best to keep things clean). If your pre has two sets of main outs then one set can go to the sub and the other to the amp.

I believe that if you get the 2-channel right, then you'll enjoy your movies almost as much.
I had the same question for my own system. I didn't want the HT corrupting the 2 channel--since 2 channel is really my passion. I went with an pre-amp that as a 2 channel bipass for my 2 channel system. Then I use this bypass for the 2 main channels in the HT system. While it's not important for the general discussion--the preamp is a Mark Levinson 380S, and the HT processor is an EAD Ovation. There are many great 2 channel pre-amps that have this bi-pass option.