using M-L Aerius as center speaker

Adamanteus what type of speaker cable are you using? I have ascent front ,theater center,aeon surround,I'm also using B&K amp,but I was looking for a good cable, right now I have a DH labs Q-10 ,but I feel that the back ground noise is too loud,or during some movies passage sometime you can hear the shhhh thru the speakers.somebody told me that maybe my amp,wish I don't think is the problem.

regards.Armando

Armando

I use Monster (8 ga) for the fronts - which are biwired- and Signature "Signaflex" for center and surrounds (12 ga). No one has yet been able to sell me on all these mystical qualities that obscenely prices speaker cables are supposed to impart. Here I side more with the EEs than the audiophiles. YMMV.

BTW, these cables are doing a very fine job and I'm not sure that spending any more would yield much more benefit. Thing to keep in mind with speaker cables is the shorter the signal path the better, all the while mindful of keeping impedance as low as possible.

Regards. Hope this helps a little.

ADAMANTEUS.

Do they sell this cables as a made set? or you made it yourself? and the rear as well?

Armando-

Just find a Monster dealer and order the total length you need. You can biwire if that strikes your fancy, or let the dealer do it for you (a little soldering involved and if you're not handy with an iron, better let the dealer do it.)

The Signature stuff is usally available at high-end shops (think it goes for around 70cents/foot. Again, order the length you need, cut if for the three runs you're going to make, and connect accordingly. Drop me a line if you need more help.

Cheers

Adamanteus

Thanks for the help.I will let you know what i'm going to do.

Armando