2. home-theater
  3. 1043841719

Rcver sub output avail: both LFE + 2 Ch stereo?

I'm looking for a <$700 HT receiver that will provide (5/6/7).1 typical DD/DTS LFE subwoofer output AS WELL AS true musical sub output through the same jack for conventional two channel stereo.

I've owned two decent lower end units, and the sub out jack has only provided output in DD/DTS mode. I've used the front preamp outputs to drive the sub for two channel, but that solution required minor but constant rewiring for LFE.

TIA!
ksnh
sogood51
2,157 posts
 
My sony sacd player has two channel+sub output, it is analog output.
ksnh OP
2 posts
 
I'm looking for feedback about receiver sub outputs. I want the following setup, and have received conflicting info regarding feasibility: connect one receiver's sub output to one powered sub and have get both home theatre low frequency effects AND two channel music listening without cable swapping.

Thanks!
vedric
46 posts
 
I believe most reasonably priced recievers should have three modes for setting up a subwoofer.

On my Yamaha I have a setting called LFE/BASS OUT. The 3 selections are 1.Subwoofer 2.Mains 3.Both. Using the "Both" setting, my subwoofer is active for 2ch. listening.

Since I run my mains full range "large" I have to use my subwoofers high pass crossover to eliminate any base frequency overlap. In my situation a setting of 40hz works.

If you set your mains to "small" then your reciever will send everything below its internal crossover setting to the subwoofer. A better reciever will allow you to adjust this crossover setting in more refined increments over a lower frequency range. Though I do not know just how feature rich most new recievers are in this area.

Im sure you can find a reciever within your budget with such a feature. Your dealers should be able to show you this feature.

Vedric
More to discover