Short Out Plugs


I stumbled on this concept in one of my pre-amp manuals. The factory recommends I use SHORT OUT PLUGS in all my unused inputs. I've seen them for sale but $6.00 per pair seems a little steep. Can I make them myself? If so how?
128x128glen
Thanks guys. Dare I ask if these plugs would be useful in other parts of my system. Unused amp or dac inputs? Please let me know. I only want to make one trip to RADIO SHACK. Again many thanks for the money saving suggestion.

Sean, is there anyway to make a shield plug?
I read an article in Audio Amateur about potting circuits that the type of silicone that comes in caulking tubes is corrosive. According to this article, the vinegar smell comes from acetic acid. I'm no chemist, but I would find out before putting it on connectors. I guess it is no big deal on some 50 cent plugs, but I'd hate to ruin something expensive.
Wow, i didn't catch that part of "Notdigital's" post. Herman is correct. The acetic acid in MOST silicone is corrosive. If you were to seal the rear section of the shunts up, you might want to seek out some non acidic silicone or apply standard silicone and let it fully cure before installing them on the preamp. You can tell when it is fully cured because the smell is MUCH less pungent.

I really don't think that this step is necessary though, as the RCA's would normally be "open" and exposed to anything floating in the air as it is. Just putting the "shunts" on and covering the soldered area with the supplied caps should be more than enough. Since the shunts would basically seal the internals of the RCA plug, the only thing left to corrode or collect dust / dirt would be the "shorting strap" inside the shunt. At $3 for a package of 8, i think that we can afford to replace them once in a blue moon.

While i have never made "caps", i would assume that you could buy the same RCA's and simply ( and carefully ) pull the center pin out. Fold the ground lug over to the other side of RCA "ring" and solder away. While not nearly as glamorous or "high grade metal" as the Cardas pieces, it should be just as effective IF you fill in all of the rear gaps with solder. Hope this helps.... Sean
>
Hi this is an interesting discussion but is there a difference in sound when using shorting plugs?
Thanks Sean. I'll take a look at the silicone I just bought. I may omit this step completely. Sws2 I don't know yet but I am going to find out. The engineer's at Theta thought enough of this procedure to mention it in the manual. Could someone tell me if it is safe to use these plugs on an amp or a dac before I try it? I do enough smoke testing at work. I'd like to avoid it at home if possible:~)