Best Phono stage for a .3 mv Ruby 2 ?


Hi All,
I am currently using an arc ph-3 which is set up for my rega super elys. I just got a new Basis 2500/graham/ruby 2 and find the ph-3 is set too low. I'm going to try clipping in some of the supplied ARC resistors. In searching around I see that quite a few people recommend a solid state preamp with this low output of a cartridge.

What is the best phono stage for a .3mv ruby 2 ?

I have heard that the new lukaschek is quite good with this combination. I also have a used aleph ono on the way.

My system is aleph P/aleph 2/avanti centuries. I do have a vk-5i pre that I'll try with the different phono stages.
john_l
The Boulder has 47 dB S/N according to Stereophile or is 38 dB noisier than the Vendetta tested by Audio Magazine about fifteen years ago.....Updated units are still available in a full function preamp made to order.....Time marches backwards :-)
Pretty amusing Rcrump. Just about matches up with my experience with them at CES when they told me I was stupid for thinking that audiophile power cords made any difference in the sound of equipment.
I use my Ruby 2 with the CAT signature phono stage. Seems like a match made in heaven, the Ruby likes to be loaded down to about 700 ohms,IMHO much airier and resolving than at the standard 47K.
Plenty of gain with the CAT, even had enough gain with my older Ruby that put out 0.2mv
Albert, I just restated the facts as they have appeared in print....Power cords make a difference?
Pretty amusing Bob, hope no one thinks you are serious as it could hurt your own power cord sales.