Best Phono stage for a .3 mv Ruby 2 ?


Hi All,
I am currently using an arc ph-3 which is set up for my rega super elys. I just got a new Basis 2500/graham/ruby 2 and find the ph-3 is set too low. I'm going to try clipping in some of the supplied ARC resistors. In searching around I see that quite a few people recommend a solid state preamp with this low output of a cartridge.

What is the best phono stage for a .3mv ruby 2 ?

I have heard that the new lukaschek is quite good with this combination. I also have a used aleph ono on the way.

My system is aleph P/aleph 2/avanti centuries. I do have a vk-5i pre that I'll try with the different phono stages.
john_l
Pretty amusing Bob, hope no one thinks you are serious as it could hurt your own power cord sales.
Albert, I think everyone here knows what I do for a living as well as my warped sense of humor.....For those that have never heard of me below are my companies.....

Bob Crump
TG Audio/CTC Builders/DDR Mfg
Has anyone set up the ph-3 with the ruby 2 ?
I am using the aleph ono now. Very very transparent and revealing. I would like to hear the ph-3 too. Has anyone set up an ph-3 with the ruby ? What resistors do you use ?
My preamp has a variable gain setting for each input, so I can ramp it up.
The ono has 76 db of gain, the ph-3 only 54.
Has anyone set up the ph-3 with the ruby 2 ?
I am using the aleph ono now. Very very transparent and revealing. I would like to hear the ph-3 too. Has anyone set up an ph-3 with the ruby ? What resistors do you use ?
My preamp has a variable gain setting for each input, so I can ramp it up.
The ono has 76 db of gain, the ph-3 only 54.
John,
I have a Ruby2 as well. I thought about using a PH-3 but I do believe 54db of gain is too low. I know of one reviewer in Listener who said it was a good match with the Linn Klyde.
I had a Klyde for a long time and it's about .25 mV, even lower than the Ruby2. A local dealer who carried Audio Research and Linn told me 54db gain was not enough for the Klyde. So my guess is it's not enough for the Ruby2.
I find the Ruby2 needs 60db gain or more for best performance. As far as loading goes, it's a toss up. I'd start at 500 ohms and move up. If your system can tollerate a bit brighter sound go higher in value. My Naim 52 uses 540 ohms and is a good match. I recently had a trial of a PP1/T-9 and it has 22k worth of loading. I did not feel the increased loading brightened the sound more than the Naim. But it did give better bass and a much fuller bigger overall sound. My biggest difference was seen in the two cables I was trying, the Harmonic Technologies Silver and the new Graham cable (50 or 70 ?). I liked the PP1 but want to try some diferent models, ie., the EAR 834P. I heard one once on a Orbe/Graham set up and fell in love with it for classical ensamble recordings. Anyone heard them both?
I would like to see the PH-3 with a 60-62 db gain.
GerardFF