Step-up Transformer, what's lost?


Hello all:

I'm currently on my third phono-pre, and I still don't have enough volume! My cartridge is a low output MC (0.23mv), so, by the time I get the volume to my listening level, I get a hiss from the tubes, or a scratch from solid state during the quiet passages of music.

I'm thinking about adding a step-up transformer but I'm afraid of losing detail.

What is the collectives' experience with the trade-off when adding a transformer?
consttraveler
G_m_c and Sidssp are right. 65 db gain in your phono should have enough gain for your cartridge.
Consttraveler,
I believe you won't be satisfied with step-ups. However, many audiophile use them with satisfaction. I guess it all depends on your expectations. I was not satisfied with step-ups because I knew what the sound quality was supposed to be like without step-ups even though without dynamics. The sound did changed for sure. I never liked SS step-ups. I had tried 4, including the one made by Benz Micro. Tubed step-ups are very difficult to perfect because of different tubes have different sonic characters, trying to get the sound you want to match tubed step-up and your tubed preamp and phono section means endless tube rolling. I did all that and through with it.
Your choices are, if you don't want to change cartridge, to try different step-ups. Based on 0.23mV output, your phono must already be a high gain phono. Be very careful when you add a step up. Too much gain will really be a bad thing, I have tried that, it sounded aweful. Or, get a phono stage with even high gain. If your phono stage is already high gain, do not use a step-up period.
G m c,
most of the times, the step up just does the trick being passive voltage amplification device connected to the minimal amplification circuit having less length of a higher gauge wire than it would be in the cartridge coil with the high output and moreover matching impedance with no additional adjustement to the load section of the phono.
MM phono-stage(especially stand-alone) coupled with step-up transformer can do about the same trick as it would the whole MC phono but and again but depending on the quality of the transformer which might be even more sophisticated to build than an electronic stage. Currently if the author uses MM version of Herron I believe that the cartridge is not properly loaded as well.
Dynavector as far as I know also produces step-up tranny with built-in set of wires. Ortofon T1000 has built-in set of wires as well. If you will order brand-new Quicksilver you can also request built-in set of wires thus you will avoid extra connection.
Marakanetz, i understand what you and TWL are saying, but in my mind, (following the mantra of Keith Herron (Why am i thinking of Kieth Herring?)), more interconnects, more connections, more wobbles, are not good. Is less better? I would sell the mm, and buy an mc, let the connections be solder, silver solder, I hope, and eliminate variables.