Off center stylus - Does this affect sonics ??????

Paulwp thanks for the response. I mounted the cartridge using the protractor supplied by Rega. I made sure that the cantilever was parallel to the lines on the protractor. The cartridge isn't square in the headshell. The stylus/needle is off center in the cantilever housing. It just doesn't look right..............

YW. It seems you did the right thing under the circumstances, but cantilevers are usually tapered, so it must be very difficult to align. But there's more. Without seeing it in person I would be a little worried about it leaning a little one way or the other and about a potential affect on compliance and the tracking and tracing performance of the cartridge in general. The cartridge is not designed to be put into use in that condition, so I'd follow Sean's advice and take it back. If they are unwilling to take it back, do they have a serious test lp to use with an oscilliscope?

Paul

For what it's worth, as a former dealer and user-most Grados are off centered. When I brought it to Joe Grados attention, he said "no big deal". Oh well.
Curt

I appreciate all the responses. I bought the unit new in a sealed box from a fellow member. I've brought it to his attention and he is going to check with the importer. We shall see what becomes of it after that. I certainly hope that this issue is handled in a professional manner too. I have removed it and I'm waiting for a response from the seller..........

If the cantilever / stylus is off-center, i would not expect optimum reproduction. However, I would expect a higher noise floor, less than optimum stereo imaging, excessive disc wear, etc... Any company that knowingly ships out cartridges with this problem obviously lacks quality control and should be avoided like the plague. Sean
>