alternate method of bi-wiring

OH NO! It's starting all over again! Run for your life! Garfish, could you pass the fondu to Sugarbrie?

No Maxgain. Get the Shotgun!!! The Bi-Barrel variety.

For Japanese gear the correct term must be "Shogun".???

Does everyone here bi-wire their speakers?

I think I am the only one that doesn't bi-wire around here.

I just got some Goertz silver jumpers. These jumpers are solid silver and 10 mm thick. Hmm...... they sound better than bi-wire in my system.

Viggen, My comment to you about not bi-wiring is better comes from earlier posts by others. Unless you tried a double run of the cable you are using for a single, against the jumpers, I am not surprised you may find the jumpers better. Probably in all cases, the stock jumper should be trashed in favor of what you are doing.

A cheaper (or different) bi-wire cable will not always perform as well as a better single cable, for the reason the single cable is just better, not because of bi-wiring.

I guess you would need a double run or a bi-wire version of the same cables to do a good comparison. B&W actually recommends bi-wiring with their speakers.

I have been biwiring for at least 10 years;still don't have the terminalogy lingo down.Most all that time I had 2 complete sets of wires. --Doubled up on the amp posts. EACH and EVERY time I started with run and jumpers; EACH and EVERY time the improvemnts ,adding the second run were huge. --This applies to using Analysis jumpers, before adding the second run, as well. And yes a quality single run with jumpers,betters less quality bi wires.