Spindle oil


What oil are people using to lubricate their spindle bearing?
scottht
John: Thanks for making me aware of that fact as i was not aware of it.

Herman: High quality linear tracking arms aren't that expensive. That is if you don't mind buying used, can shop around on the net and move fast once you find one. Sean
>
Herman..."Crab walking"? I'm not sure what you mean. The Sony PS X-800 arm actually does have a pivot. However, the arm angle is constantly measured, (Hall effect sensors) and the pivot point is moved as necessary to keep this angle tiny. The pivot movement is biased to match the nominal LP groove spacing. Only if the groove spacing changes from nominal does an arm angle develop, and the pivot movement speed varied so as to get the arm angle back to zero (plus or minus 0.05 degrees). At all times the arm is free to pivot, so the servo activity is not seen by the pickup.

Bottom line is that it works flawlessly, and the biotracer vertical servo (not on all Sony linear tracking TT) will handle warped records that would be unplayable on most systems. Another nice feature of the biotracer arm is that the VTF is applied as a bias to the servo, and can be adjusted WHILE a record is playing, so that sonic effects of VTF can be evaluated.
El: I think that Herman meant that the servo controlled linear arm would be cogging side to side ( crab-walking ) trying to constantly correct for the center of the groove. Sean
>
El, it has to have some amount of cogging, otherwise there wouldn't be any need for the sensors. Every time it makes a correction it cogs and with an off center record it would be doing so continuously. Of course it is another matter whether this detracts from the sound.

I'm curious where the sensors are mounted in relation to the pivot point. Your spec of .05 degrees seems like an awfully low figure. With a 3 inch arm that would be about 70 microns at the stylus. I'm not saying it can't be done, but that does seem awfully low for a consumer table.

While I agree that it is an interesting exercise in engineering, one has to wonder why nobody builds such a system anymore. In the cost is no object world of high end audio things like stepper motors, hall effect sensors, and microprocessor controllers are dirt cheap. Perhaps it is a matter of perception given the amount of trashing they took early on.