Has anyone used electronic pocket scales for VTF?

Have one too. At less than $30 it is great. I see ones on sale here for hundreds of dollars! I find mine to be very accurate too.

I have a similar one. It works, but the problem is getting the right vertical height to place the scale so it is the same height as a record. Typically I have to place the scale on a block off to the side of the platter, and then place the sytlus on the edge of the scale. This seems to work, but it is a lot more hassle than the dedicated digital stylus force scales. (My friend has one, and it works much easier. I did check that the scales measure weights the same, and they do seem to, more or less.)

If you are looking for a small weight to check the scale, a 1982 through current penny weighs about 2.5 grams. An older (pre 1982) penny weighs about 3.1 grams.

"It works, but the problem is getting the right vertical height to place the scale so it is the same height as a record. I have to place the scale on a block off to the side of the platter, and then place the sytlus on the edge of the scale"

I can take my platter off the spindel. Then I place the scale on a small pad of paper with enough sheets taken off the pad so that the pad plus scale is the same height as the platter plus record. I measure dead-on with where the stylus would be on a record.

Takes about a minute more than the dedicated digital scales and you save at least $100!

I have the Audio One from Audioparts Inc that auctions here on AudiogoN, I have found it to be the easiest of all to use. It is more money that the stock digital scales, but it is much easier to use since it is never necessary to reset the VTA of my tonearm in order to get an accurate reading. The inexpensive digital scales are just to thick to make the process simple and the A1 solves this problem beautifully.